Spoilerboard Surfaces Options for Getting Good Cuts
2 posters
Discuss the Donek Tools Drag Knife :: Donek Tools General Discussion Topics :: General Message Board
Page 1 of 1
Spoilerboard Surfaces Options for Getting Good Cuts
I plan to use the D2 on a Shopbot Alpha to cut corrugated cardboard, coroplast and occasionally leather and I'm looking for alternatives to an expensive 48x96" self-healing mat to cover the MDF spoilerboard. I'm assuming MDF would quickly dull the blade, and might not yield clean cuts. Any suggestions appreciated.
RickWashburn- Posts : 1
Join date : 2014-01-28
Re: Spoilerboard Surfaces Options for Getting Good Cuts
We have used a MDF cutting surface for years without any problems. Typical setups don't involve cutting into the spoil surface anyway. You want to zero your tool so that it just cuts through the material.
Discuss the Donek Tools Drag Knife :: Donek Tools General Discussion Topics :: General Message Board
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|