CamBam circle commands

View previous topic View next topic Go down

CamBam circle commands

Post by alevitt53 on Tue Apr 08, 2014 4:25 pm

Hello,
New to the forum and just purchased the D4. Will the corners action work with the g-code produced by CamBam?
I tried it and got the error "The file contains circle commands" and I do not know how to change that in CamBam.
Any help would be greatly appreciated.
Thank you

alevitt53

Posts : 1
Join date : 2014-04-08

View user profile

Back to top Go down

Re: CamBam circle commands

Post by DonekTools on Mon May 12, 2014 11:13 am

I am not familiar with CAMbam. You will need a non arcs post processor. If you contact CAMbam's support, they should be able to guide you if there is not one immediately visible in your list of post processors.
avatar
DonekTools
Admin

Posts : 46
Join date : 2013-05-19
Location : Watkins, CO

View user profile http://donektools.com

Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum