Donek Dragknife, V Carve Pro, and Shopbot Desktop
2 posters
Discuss the Donek Tools Drag Knife :: Donek Tools General Discussion Topics :: General Message Board
Page 1 of 1
Donek Dragknife, V Carve Pro, and Shopbot Desktop
I reviewed your video pertaining to creating a file and cutting material. The problem I'm encountering follows: My Z setting is 0 the bottom of my mylar whose thickness is .021. I created and saved a file , clicked on gadgets, clicked on Dragknife Toolpath, zeroed out my x,y,z axis, opened file plan, selected file, started the file, however, the drawknife failed to cut the mylar, it did cut the file but as an air pass. Any suggestions?
Stephen50- Posts : 1
Join date : 2014-04-18
Re: Donek Dragknife, V Carve Pro, and Shopbot Desktop
Sounds like you zerod your machine incorrectly. You need to zero the tip of the blade to the table surface.
Similar topics
» Fusion 360 DragKnife Add On available!!
» For Sale Donek D3
» What is the Donek Tools Swivel Program
» Donek Tools Project show and tell
» New Donek D4 user learning curve
» For Sale Donek D3
» What is the Donek Tools Swivel Program
» Donek Tools Project show and tell
» New Donek D4 user learning curve
Discuss the Donek Tools Drag Knife :: Donek Tools General Discussion Topics :: General Message Board
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|