Tool path not closing squares
2 posters
Discuss the Donek Tools Drag Knife :: Donek Tools General Discussion Topics :: General Message Board
Page 1 of 1
Tool path not closing squares
I just received my drag knife and wanted to calibrate it using a pattern of squares with different offsets and swivel heights. I am satisfied with the corners of my middle squares, however for some reason the blade path doesn't go all the way on the last leg of the cut to fully connect the square
as you can see its the bottom left corner of all the squares... I made the tool path in VCarve Pro 7 using the dragknife gadget.
Any help would be appreciated.
Thanks,
Krys
as you can see its the bottom left corner of all the squares... I made the tool path in VCarve Pro 7 using the dragknife gadget.
Any help would be appreciated.
Thanks,
Krys
allen00se- Posts : 3
Join date : 2014-02-28
Re: Tool path not closing squares
The vectric gadget does not finish well at a corner. You have to put.your start points in the middle of a straight line.
Re: Tool path not closing squares
I have looked around and I cant find any info about how to set the start points for the drag knife gadget... do you have a link for me to look at?
allen00se- Posts : 3
Join date : 2014-02-28
Re: Tool path not closing squares
nevermind.. just found it. Just edited the nodes and right-click > make start point.
allen00se- Posts : 3
Join date : 2014-02-28
Similar topics
» Fusion 360 drag knife tool path creation
» entry path
» getting arc tool paths
» Do I need a new license for the drag knife tool and sheetcam?
» Precision cut-outs: tool placement and hold downs
» entry path
» getting arc tool paths
» Do I need a new license for the drag knife tool and sheetcam?
» Precision cut-outs: tool placement and hold downs
Discuss the Donek Tools Drag Knife :: Donek Tools General Discussion Topics :: General Message Board
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|