Discuss the Donek Tools Drag Knife
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Discuss the Donek Tools Drag Knife

Cardboard Settings

Discuss the Donek Tools Drag Knife  :: Software Discussions :: Vectric Drag Knife Gadget

Go down

Cardboard Settings Empty Cardboard Settings

Post by akafrk Fri Jun 13, 2014 3:21 am

Hello, I am looking for Aspire what are the settings in Dragknife Toolpath Dragknife Gadget to cut cardboard (between 2 and 5 mm) with a tool D4
And what is the tool that can indicate
thank you

akafrk

Posts : 1
Join date : 2014-06-13

Back to top Go down

Back to top

- Similar topics

Discuss the Donek Tools Drag Knife  :: Software Discussions :: Vectric Drag Knife Gadget

 
Permissions in this forum:
You cannot reply to topics in this forum