Discuss the Donek Tools Drag Knife
Would you like to react to this message? Create an account in a few clicks or log in to continue.

corruplast cuts

2 posters

Go down

corruplast cuts Empty corruplast cuts

Post by Juan Hidrovo Tue Oct 27, 2015 11:30 am

Hi.

This cuts were done using CUT2D and D4 dragknife.  Exacto blade #11.
The program does not support any corner action or offset.
Change the blade to help on corners.
Not bad at all final results.

Triyng to upload images from my mac but cannot do it.  Any help please.

Thank You

Juan Hidrovo

Posts : 1
Join date : 2015-10-27

Back to top Go down

corruplast cuts Empty Re: corruplast cuts

Post by DonekTools Tue Oct 27, 2015 12:03 pm

Juan,

You will most likely have to upload them to another service or site and link to embed them. You could also e-mail them to info@donek.com and I will handle it for you.

The latest version of cut2d is suppose to have the drag knife gadget.
DonekTools
DonekTools
Admin

Posts : 48
Join date : 2013-05-19
Location : Commmerce City, CO

http://donektools.com

Back to top Go down

corruplast cuts Empty Re: corruplast cuts

Post by DonekTools Tue Oct 27, 2015 1:32 pm

corruplast cuts 12049173_633755000101014_2090850004289891237_n
corruplast cuts 12049288_633755003434347_152267369042695053_n
corruplast cuts 12039508_633755036767677_5980937213266182197_n
corruplast cuts 11051805_633755030101011_6986633932043505709_n
corruplast cuts 12193753_633755026767678_8865564584632609952_n
DonekTools
DonekTools
Admin

Posts : 48
Join date : 2013-05-19
Location : Commmerce City, CO

http://donektools.com

Back to top Go down

corruplast cuts Empty Re: corruplast cuts

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum