cutting cork with the drag knife
Page 1 of 1
cutting cork with the drag knife
Thought i would try an exacto blade and it worked finr ,the holder accepted it and the cut was good.
Holding down the work piece is always a challenge
woodman13- Posts : 5
Join date : 2013-05-24
Similar topics
» Do I need a new license for the drag knife tool and sheetcam?
» An Introduction to the Vectric Software Drag Knife Gadget
» using google sketchup with donek d4 drag knife problems
» Fusion 360 drag knife tool path creation
» more cutting but using aspire to generate the toolpath
» An Introduction to the Vectric Software Drag Knife Gadget
» using google sketchup with donek d4 drag knife problems
» Fusion 360 drag knife tool path creation
» more cutting but using aspire to generate the toolpath
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|