Discuss the Donek Tools Drag Knife
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Cutting issue with small dimensions

2 posters

Go down

Cutting issue with small dimensions Empty Cutting issue with small dimensions

Post by wiltech Sun Dec 14, 2014 11:27 pm

I'm using a D4 and doing chinese characters on sticker paper, the problem is the toolpath does not seem to be correct when I do the cutting.

Need your help ASAP.

Thanks.

JR

settings screenshot

wiltech

Posts : 2
Join date : 2014-12-14

Back to top Go down

Cutting issue with small dimensions Empty Re: Cutting issue with small dimensions

Post by DonekTools Mon Dec 15, 2014 10:07 am

The D4 is going to struggle with small details, particularly with the Vectric Gadget. SheetCAM will make it possible to generate very fine detail in these cuts because it implements offset compensation. The Vectric Gadget only performs corner actions. The smallest part you ware likely to be able to successfully cut with the vectric gadget and a D4 with a standard blade is a 1/4in circle. You could switch to a Safety blade and get a bit better result.
DonekTools
DonekTools
Admin

Posts : 48
Join date : 2013-05-19
Location : Commmerce City, CO

http://donektools.com

Back to top Go down

Cutting issue with small dimensions Empty Re: Cutting issue with small dimensions

Post by wiltech Mon Dec 15, 2014 10:17 pm

Thanks for your reply. we opted to cut manually does that are not doable with D4

wiltech

Posts : 2
Join date : 2014-12-14

Back to top Go down

Cutting issue with small dimensions Empty Re: Cutting issue with small dimensions

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum