construction of a vac table and tests following
2 posters
Page 1 of 1
construction of a vac table and tests following
using Sean Martin's ideas on a vac table ,I re-designed it a bit and built one 28x48 in and I am showing the construction and the testing that follows
It works fine
https://youtu.be/ZlavIPiicCM
woodman13- Posts : 5
Join date : 2013-05-24
Re: construction of a vac table and tests following
Stan,
It looks like your offset values are off. This could be due to your blade selection. The Irwin blades when installed right up against the stops will yield the exact same result every time with very sharp clean corners.
It looks like your offset values are off. This could be due to your blade selection. The Irwin blades when installed right up against the stops will yield the exact same result every time with very sharp clean corners.
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum