ultrasonic cutting
2 posters
Discuss the Donek Tools Drag Knife :: Donek Tools General Discussion Topics :: General Message Board
Page 1 of 1
ultrasonic cutting
Any ideas on how to incorporate an ultrasonic cutter in a drag knife?
https://www.youtube.com/watch?v=s4JduhPSMJ8
https://www.youtube.com/watch?v=s4JduhPSMJ8
rickluau- Posts : 1
Join date : 2015-10-20
Re: ultrasonic cutting
In that video it's being done on a machine with CNC angular blade positioning/rotation... thus not a drag knife.
I've used hand held ultrasonic cutters - they are pretty good. I think it'd be really hard to do drag since the blade has to be coupled to ultrasonic horn & converter (5-15lbs 2-5" diameter, 8-10" long)... good luck getting that to free spin.
I've used hand held ultrasonic cutters - they are pretty good. I think it'd be really hard to do drag since the blade has to be coupled to ultrasonic horn & converter (5-15lbs 2-5" diameter, 8-10" long)... good luck getting that to free spin.
catsh16- Posts : 3
Join date : 2015-10-29
Similar topics
» cutting foam
» more cutting but using aspire to generate the toolpath
» cutting cork with the drag knife
» Cutting 3/16" foam boards, need advice
» Cutting issue with small dimensions
» more cutting but using aspire to generate the toolpath
» cutting cork with the drag knife
» Cutting 3/16" foam boards, need advice
» Cutting issue with small dimensions
Discuss the Donek Tools Drag Knife :: Donek Tools General Discussion Topics :: General Message Board
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|